TricepsBeginner

Standing Bent-Over Two-Arm Dumbbell Triceps Extension

Strength movement using Dumbbell.

1 / 2

Muscle guide

See the primary and supporting muscles.

The stronger highlight marks the main muscle associated with this movement. The lighter highlight marks supporting muscles.

Primary Triceps

Movement instructions

1
With a dumbbell in each hand and the palms facing your torso, bend your knees slightly and bring your torso forward, by bending at the waist, while keeping the back straight until it is almost parallel to the floor. Make sure that you keep the head up. The upper arms should be close to the torso and parallel to the floor while the forearms are pointing towards the floor as the hands hold the weights. Tip: There should be a 90-degree angle between the forearms and the upper arm. This is your starting position.
2
Keeping the upper arms stationary, use the triceps to lift the weights as you exhale until the forearms are parallel to the floor and the whole arms are extended. Like many other arm exercises, only the forearm moves.
3
After a second contraction at the top, slowly lower the dumbbells back to their starting position as you inhale.
4
Repeat the movement for the prescribed amount of repetitions.

Technique guidance

Exhale as the target muscle shortens against resistance and inhale during the controlled return. Keep breathing steadily throughout the set.

Use a stable setup and a load or resistance you can control through a comfortable range.
Stop if you feel sharp pain, dizziness, or feel unwell.
Keep the area clear and use a load you can lift into position and lower without dropping.

General guidance matched from movement type and equipment; it is not individualized coaching or medical advice.

Related movements